Once you have the die on 2 or 3 turns the bolt can be put in the vice.The die will have to be turned backward to remove the swarf and to prevent it jamming.Do not turn on the lathe just turn the chuck by hand.Use the 8mm x 1.25 die on the tailstock to start the thread this will keep it square and straight.Remove the drill chuck from the tailstock and move towards the work.Measure your work it should be close to 8mm. Includes: Simply push the assembly into the hole, hold the flange nut with a. You can then turn the rest of the bolt down to using the step as a guide Use this tool to install 5/16-18 (thread) Rivnuts on your off road Jeep Wrangler.Cut a small step on the end to the correct diameter (8mm).Remember to set the tool to the correct height and only use the tip of the tool.Wind the nut onto the bolt and mount tin the lathe chuck.Short arms (AK3984) provide effortless functionality and access in restricted spaces. First, mark the length with a marker pen Suitable for rivet nuts in aluminium, steel and stainless steel.You can slide show the photos and read the notes or read the instructions below or both. It can be difficult to cut the thread straight, the instructions will show you how to get the thread perfect. You will need to machine the end of the bolt down to 8mm diameter the length of your Rivnut fastener, this is a little tricky, make sure the bolt and it very tight in the lathe chuck as the threads tend to push the bolt into the chuck when the tool is cutting. Look out for long pieces of Swarf as it can be sharp and hot.With the 12mm drill you need to bore out the hole almost all the way through using the mark as a guide.Measure the material and transfer that measurement to the 12mm drill with a marker pen. RIVNUT® blind rivet nuts and RIVSTUD® blind rivet studs with hexagon shank can be easily and directly fed in correctly in all spatial positions, even upside down.Next drill all the way through with an 8mm drill.Use a 6mm drill to drill all the way through, you will need to back the drill out to clean the swarf to prevent jamming or breaking the drill.Always use a little cutting fluid to keep the drill cool and help with cutting.ĭrill about halfway up the tapper of the center drill.Use the center drill to drill a small pilot hole, this will keep the hole centered and stop the drill from breaking.Mount the solid in the lathe and make sure it runs true and is tight.You will need around 30mm of round solid bar, which can be cut in the bandsaw or by hand.If you have not used a lathe before, check with your teacher as things can go bad very quickly if you put your hand or clothing in the wrong place. This tool is for 8mm Rivnuts, You will have to change some of the sizes if you want to use a different size bolt or Rivnut.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |